Multitech MTPSR1-202ST Guida Utente Scaricare il pdf (Pagina 9)

Cabling

3 To make the network connection, connect one end of an

RJ-45 (UTP) cable to the 10 BASE-T connector on the back

of the ProxyServer as shown in Figure 3. Connect the other

end of the cable to your LAN.

4 Connect one end of an RJ-45 cable to the ISDN

connector on the back of the unit and connect the other

end to the ISDN Telephone Network (Telco wall jack) as

shown in Figure 3.

5 If desired, connect an analog phone set to the PHONE

jack on the back panel of the ProxyServer.

6 Turn on power to the ProxyServer by setting the ON/OFF

switch on the back panel to the ON position. Wait for the

red Fail LED on the ProxyServer to go OFF before

proceeding. This may take up to two minutes to go

OFF.

At this time your ProxyServer is completely cabled and

powered on. Proceed to the next section to load your Proxy-

Server software.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Nessun commento

Multitech MTPSR1-202ST Guida Utente Pagina 9