MultiAccess®ACS Analog Communications Server MA100-1M Quick Start Guide

MultiAccess ACS Logging In Again Having reset the IP address of the administrator’s PC, you must log into the MA100-1M software again. Enter the MA

Quick Start GuideSetting Up the Mail Server 1. From the Administration screen, go to the SMTP Configuration fields. 2. Enter the mail server addre

MultiAccess ACS MultiAccess for dial-out, you will have to select one of the Modem Sharing options and select the Country Code. With any of the Mode

Quick Start Guide13 Raw Mode with No Authentication. User data is treated “as is”, without interpretation, and no authentication is required. Raw Mode

MultiAccess ACS Radius Client Setup points to the Radius Server when the Authentication is Radius. Authentication 1. In the Authentication Type, i

Quick Start Guide2. Enter the port number (usually 1812) for the RADIUS Server in the top Port window. 3. Enter the IP address of the RADIUS Accounti

MultiAccess ACS 16 1) a fixed telephone number. This is enabled by choosing Admin specified in the Callback window. 2) a variable telephone number

Quick Start Guide17 Users Row: 1. In the next blank Name row, enter the Name and User ID of your local user. 2. In the Password window, enter an alp

Patents This device is covered by one or more of the following patents: 6,031,867; 6,012,113; 6,009,082; 5,905,794; 5,864,560; 5,815,567; 5,815,

MultiAccess ACS 2 MultiAccess ACS Quick Start Guide MA100-1M P/N 82010243L, Revision D All rights reserved. This publication may not be reproduced,

Quick Start Guide3 Introduction This guide shows you how to setup your MultiAccess ACS (Analog Communications Server) single-port communications serve

MultiAccess ACS 4 We Supply • A MA100-1M with factory-installed software • A set of four self-adhesive plastic feet • One mounting bracket • One

Quick Start GuideAttaching the MultiAccess to a Fixed Location 1. Typically, the MultiAccess is mounted against a flat surface with two mounting sc

MultiAccess ACS Installation Process 1. Plug the DC power transformer into a power outlet or power strip. Secure the other end to the PWR jack on yo

Quick Start Guide3. Plug one end of your RJ45 ethernet cable into the MA100-1M’s ethernet jack and the other end into your network ethernet hub. Thi

MultiAccess ACS 8 Setting Admin PC to Startup IP Address 1. Connect a PC to your network. Record the pc’s current IP address. 2. Set the PC I

Quick Start GuideSetting MA100-1M IP Addresses 1. In the MA100-1M Administration screen, go to the IP Configuration fields. 2. Fill in the IP infor