Multitech MVPGK1 Guida Utente Pagina 33
- Pagina / 87
- Indice
- RISOLUZIONE PROBLEMI
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
MultiVOIP Gatekeeper User Guide 33
Chapter 5 - Hardware Removal/Replacement
Floppy Disk Drive Removal/Replacement
1 Remove the Gatekeeper
from rack enclosure (two people are needed). Follow the
procedure Disconnecting Cables and Removal from Enclosure presented above.
Summary: after powering down the unit and disconnecting all power and signal cables,
employ two people to remove its rack-mounting screws and lift the unit out of the rack.
2 Remove the top cover from the Gatekeeper by removing the seven cover mounting
screws located in the back of the Gatekeeper. See figure 4-3.
3 Remove the two chassis mounting screws from the card cage. See figure 4-4.
4 Being careful to maintain slack in the power cables, lift the card cage, including fan
housing, up and over so that it rests along side the chassis.
5 Disconnect the power and data cables from the back of the floppy disk drive.
6 Remove the four screws securing the floppy drive to the drive chassis.
7 Open the front door and remove floppy drive by sliding it out the front of the drive chassis.
8 To install a new floppy drive, follow steps 1-7 in reverse order and sense. That is,
a. Open front door and insert floppy drive into drive chassis.
b. Attach floppy drive to drive chassis (4 screws).
c. Reconnect power and data cables to floppy drive.
Note: Before installing card cage, make sure power connectors from power supply to midplane
are fully connected (Figure 4-5b).
d. Reinstall the card cage and attach it to chassis (2 screws).
e. Replace top cover (7 screws).
f. (Two people are needed.) Reinstall Gatekeeper in rack enclosure.
CD ROM Drive Removal/Replacement
1 Remove the Gatekeeper
from rack enclosure (two people are needed). Follow the
procedure Disconnecting Cables and Removal from Enclosure presented above.
Summary: after powering down the unit and disconnecting all power and signal cables,
employ two people to remove its rack-mounting screws and lift the unit out of the rack.
2 Remove the top cover from the Gatekeeper by removing the seven cover mounting
screws located in the back of the Gatekeeper. See figure 4-3.
3 Remove the two chassis mounting screws from the card cage. See figure 4-4.
4 Being careful to maintain slack in the power cables, lift the card cage, including fan
housing, up and over so that it can rest alongside the chassis.
5 Disconnect the power and data cables from the back of the CD ROM drive.
6 Remove the four screws securing the CD ROM drive to the drive chassis.
7 Open the front door and remove CD ROM drive by sliding it out the front of the drive
chassis.
8 To install a new CD ROM drive, follow steps 1-7 in reverse order and sense. That is,
a. Open front door and replace CDROM drive in drive chassis.
b. Attach CD ROM to drive chassis (4 screws).
- MultiVOIP Gatekeeper 1
- Model MVPGK1 1
- Hardware User Guide 1
- User Guide 2
- Contents 3
- 6 Troubleshooting 35 4
- Appendices 45 4
- 1 Introduction/Description 5
- System Overview 6
- Technical Specifications 7
- SBC (Single Board Computer) 8
- Display: 9
- NIC Board (EN10100 PCI Card) 10
- Chapter 1 - System Overview 11
- 2 Installation and Setup 13
- Rack Mounting 15
- Cable Connections 15
- NIC Cabling 16
- SBC Board Cabling 16
- Powering Up 17
- 3 Single Board Computer 19
- Introduction 20
- Component Locations 21
- 4 PCI NIC Board 23
- About PCI Bus 25
- Features 25
- LED Indicators 26
- 5 Hardware Removal/ 27
- Replacement 27
- Card Cage Removal/Replacement 29
- GateKeeper 30
- Board Removal and Replacement 31
- Removing NIC Board 32
- 6 Troubleshooting 35
- Hardware Troubleshooting 36
- Chapter 6 - Troubleshooting 37
- Diagnostic Tests 38
- Calling Technical Support 39
- 7 Service, Warranty, and 40
- Technical Support 40
- Limited Warranty 41
- Ordering Accessories 42
- Tech Support 43
- About the Internet 43
- Appendices 44
- Pin Identification 45
- 6-Pin Circular Jack 46
- SBC Onboard Connectors 48
- Printer Port Connector 49
- COM 2 Port Connector 50
- Hard Disk Connector 50
- COM2 Connector 51
- External Keyboard Connector 51
- Reset Connector 51
- Floppy Disk Drive Connector 51
- Hard drive Connector 52
- Hard drive LED Connector 53
- Power Connector 53
- Expansion Slots 54
- ISA Bus Pin Assignments 55
- How to Set Jumpers 56
- Jumper Settings 57
- JP4 : CPU Clock Selection + 58
- Table B-4. DMA Channels Map 61
- Table B-5. Memory Map 61
- Table B-6. I/O Map 61
- Green PC Function 62
- Power Saving Block Diagram 63
- CPU Doze Mode 63
- System Standby Mode 63
- System Suspend Mode 63
- Award BIOS Setup 64
- Entering Setup 65
- SBC Configuration 66
- VGA Driver Utilities 67
- The BIOS Features Setup Menu 69
- Virus Warning 70
- Quick Power On Self Test 70
- Boot Sequence 70
- Boot Up Floppy Seek 70
- Boot Up NumLock Status 71
- Boot Up System Speed 71
- Gate A20 Option 71
- Typematic Rate Setting 71
- Typematic Rate (Chars/Sec) 71
- Chipset Features Setup 72
- DRAM Settings 73
- Cache Features 73
- PCI and IDE Configuration 73
- Power Management Setup 74
- Doze Mode 75
- Standby Mode 75
- PCI IRQ Activated by 76
- PCI IDE IRQ Map to 76
- Onboard PCI SCSI Chip 76
- Load BIOS Defaults 76
- Load Setup Defaults 76
- Integrated Peripherals 77
- Password Setting 77
- IDE HDD Auto Detection 78
- HDD Low Level Format 79
- Save & Exit Setup 80
- Canadian Limitations Notice 82
- Power Supply Unit 84
- Communication Module 84
- Carrier Card Expansion Card 84
- SITS/82/005S/D 85
- Compliance with BS6328 Part 1 85
- S0000122, Rev B 87
Prodotti e manuali riguardandi Componenti del telaio auto Multitech MVPGK1
Panasonic CF-19RHRCHPG manuali
Manuali dei proprietari e guide per l'utente per Notebook Panasonic CF-19RHRCHPG.
We fornisce 1 manuali pdf Panasonic CF-19RHRCHPG per scaricare gratuitamente in base al tipo di documento: Scheda Tecnica
Panasonic CF-19RHRCHPG Scheda Tecnica (2 pagine)
Marchio: Panasonic | Categoria: Notebooks | Dimensione: 1.05 MB |
Indice
Più prodotti e manuali per Notebook Panasonic
| Modelli | Tipo di Documento |
|---|---|
| CF-31ATNEXPG |
Scheda Tecnica
Panasonic Toughbook CF-31,
2 pagine
|
| CF-C1BTCFZFF |
Scheda Tecnica
Panasonic Toughbook CF-C1,
2 pagine
|
| CF-T8GWESZQG |
Scheda Tecnica
Panasonic Toughbook CF-T8 SU9400,
2 pagine
|
| CF-F8EWDZZNG |
Scheda Tecnica
Panasonic Toughbook CF-F8,
2 pagine
|
| CF-19ADNAXDE |
Scheda Tecnica
Panasonic Toughbook 19,
2 pagine
|
| CF-52EKMBUAG |
Scheda Tecnica
Panasonic Toughbook CF-52,
2 pagine
|
| CF-H1CDMAZH3 |
Scheda Tecnica
Panasonic Toughbook CF-H1 Z540,
2 pagine
|
| CF-19KHRCHPG |
Scheda Tecnica
Panasonic Toughbook CF-19 SU9300,
1 pagine
|
| CF-19CHBAXBG |
Scheda Tecnica
Panasonic Toughbook CF-19,
1 pagine
|
| CF-F8GWEZFQG |
Scheda Tecnica
Panasonic Toughbook CF-F8 SP9400,
2 pagine
|
| CF-52CCABJBG |
Scheda Tecnica
Panasonic Toughbook CF-52,
2 pagine
|
| CF-T5LWHSZBE |
Scheda Tecnica
Panasonic Toughbook Toughbook-T5,
2 pagine
|
| CF-C1ATAAGFF |
Scheda Tecnica
Panasonic Toughbook C1,
2 pagine
|
| CF-W8GWEYZSG |
Scheda Tecnica
Panasonic Toughbook CF-W8 SU9300,
2 pagine
|
| CF-52GCMBVAG |
Scheda Tecnica
Panasonic Toughbook CF-52,
2 pagine
|
| CF-Y7DWAZFSG |
Scheda Tecnica
Panasonic Toughbook CF-Y7,
2 pagine
|
| CF-31MK5 |
Istruzioni per gli Interventi
 
Panasonic Toughbook 31,
44 pagine
|
| CF-W5LWSYZBE |
Scheda Tecnica
Panasonic Toughbook Toughbook-W5,
2 pagine
|
| CF-54A0002BM |
Scheda Tecnica
Panasonic Toughbook 54,
2 pagine
|
| CF-Y5LWVYZBE |
Scheda Tecnica
Panasonic Toughbook Toughbook-Y5,
2 pagine
|
© 2020, manymanuals.it. Tutti i diritti riservati | 0.030 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale