Multitech ISI608PC Manuale del Proprietario Scaricare il pdf (Pagina 26)

ISI608PC Owner’s Manual

Removing the Driver (Windows NT)

In Windows NT, go to Program Manager » click on Main »

click on Control Panel » click on Network » click on ISI608

and choose the

REMOVE

button.

Installation in SCO UNIX

The installation utility provided by SCO is called

custom

. This

section is a brief guideline for invoking the utility and installing

the driver. The instructions contained in the following table

should only be used on SCO UNIX systems. If you are using

SCO XENIX or UNIXWare, proceed to the appropriate section.

When you have completed the steps in Table 3-3, you will be

directed to Section 3.9 for a discussion of the Multi-Tech

Installation Script.

Table 3-3

ISI608 Driver Installation for SCO UNIX

Step Procedure

1 If you are installing the driver from your default floppy

drive, type custom and press "Enter" to invoke the

custom

utility. If you are using a non-default drive, you

must inform your system of the disk drive from which

you will be doing the installation and the size and

capacity of the diskette(s). The chart below provides

the two options that may be used when invoking the

custom

utility. Insert a copy of the Multi-Tech driver

diskette, and give the appropriate command.

Disk Drive Designation

DRIVE DISK DISK

SPEC SIZE CAPAC

.ENTER THIS COMMAND

0 3.5" 720K custom -m /dev/rfd0135ds9 press "Enter"

1 3.5" 720K custom -m /dev/rfd1135ds9 press "Enter"

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 80 81

Nessun commento

Multitech ISI608PC Manuale del Proprietario Pagina 26